iPECS UCP - 3.7 Intercom Step Call

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
275
Table 4.4.2.3-1 Terminal Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
SLT configuration
mode
For the South African region, the SLT gain is adjusted based on
the SLT Configuration Mode.
Default,
Short,
Long,
Far
Default
Block Back Call
When an SLT attempts to transfer a CO/IP call to another CO/IP
Line, the transfer can be blocked and the call released.
OFF
ON
OFF
SLT Open Loop
Time
Send open loop signal to SLT port when counter party user
hangs up SLT.
0~9
(100ms)
0
Short Modem
If this value of a SLT is ON, the SLT is the modem mode in
seizing a CO line.
When the CO line is CO board, the {short modem timer} is
starting when the SLT seizes the co line. And if the {short
modem timer} is expired, the SLT goes to the original mode.
When the CO line is ISDN, the {short modem timer} is starting
after receiving the ISDN connect message. And if the {short
modem timer} is expired, the SLT goes to the original mode.
OFF
ON
OFF
Line Echo
When LKA-200 SLT is used, the echo may be hearing. If this
option is set to ON, the echo won’t be happen.
OFF
ON
OFF