iPECS UCP - Page 292

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
277
Table 4.4.2.4-1 CLI Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Call wait signal
continuous
When this filed set On, you will get the indication of Call
wait signal continuously without returning to the current
conversation. In case of Off, you will return to the current
conversation after 1 cycle of Call wait signal indication.
ON,
OFF
OFF
Call wait signal
duration (*3sec.) of a
call
You can set the call wait signal duration of a waiting call:
the default is 2 (2*3sec.) and the range is from 0 to 20.
0-20
(*3sec)
2
CLIP Display
CLIP (Calling Line Identification Presentation), a carrier
service, sends the number of the calling party to the
system in the call SETUP message. If enabled here, the
number will be shown in the iPECS Phone LCD.
OFF
ON
ON
COLP Display
COLP (Connected Line Id Presentation), a carrier
service, sends the number of the answering party to the
system in the call CONNECT message. If enabled here,
the number will be shown in the iPECS Phone LCD.
OFF
ON
ON
CLIR Service
CLIR (Calling Line Identification Restriction), a carrier
service, removes calling party ID sent from the ISDN to
the called party with a RESTRICT instruction in the
SETUP message. If enabled here, the system will send
the RESTRICT instruction to the PSTN when an
outgoing ISDN call is placed.
OFF
ON
OFF
COLR Service
COLR (Connected Line Id Restriction), a carrier service,
removes connected party ID sent from the ISDN to the
calling party with a RESTRICT instruction in the
CONNECT message. If enabled here, the system will
send the restrict instruction to the PSTN when the station
answers an ISDN call.
OFF
ON
OFF
CLI Name Display
When the Incoming CLI data from the carrier matches a
number in Speed Dial, or Outgoing dial data from a user
matches a number in Speed Dial, the system can display
the name associated with the Speed Dial bin, if set to
ON.
OFF
ON
ON
CLI/IP Message Wait
A log of missed calls with caller identification can be
maintained for the user, permitting the user to call back
the identified party. Up to 1000 entries are maintained in
the log, system-wide.
OFF
ON
OFF
FASTCLI For Transfer
Call
If this option is set to ON, when a transferred call is
routed to an SLT or DECT phone, the CLI for the CO/IP
call is sent to the SLT or DECT phone instead of
transferring station number.
OFF
ON
OFF
E.164 Call Log CLI
(for SIP Extension)
When enabled, the E.164 format CLI is sent to SIP
Extensions for an incoming CO/IP call.
OFF
ON
OFF
Station CLI 1
When not restricted by CLIR or COLR, this entry is
added to the number in the selected COIP/CLIP Table
and sent in the ISDN call SETUP or CONNECT
message in place of the station number.
Max. 12 digits
eMG80:100
eMG800:1000
UCP:1000
Station CLI 2
When not restricted by CLIR or COLR, this entry is
added to the number in the selected COIP/CLIP Table
and sent in the ISDN call SETUP or CONNECT
Max. 16
characters
Related with
PGM 143 –
Station CLI
Station CLI 3
Station CLI 4