iPECS UCP - Page 332

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
317
Table 4.4.4.1-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
CO Line COS
Each CO/IP Line is assigned a Class-of-Service that
interacts with the Station COS, refer to Table 4.4.4.1-2
CO COS 1: Station COS applies
CO COS 2: Exception Table A governs
CO COS 3: Exception Table B governs
CO COS 4: Restricts LD calls & Exception Table C
CO COS 5: Overrides Station COS 2~6 with no
restrictions.
COS 1~5 COS 1
CO Line Type
Each CO/IP Line can be assigned as connected to a CO
Line or a PBX/CTX Line.
PBX
CO
CO
Universal Night Answer
Universal Night Answer (UNA) allows any station user to
answer a call on the CO/IP line by dialing the UNA code.
OFF
ON
OFF
CO/IP Group
Authorization
Each CO/IP Group can be assigned to require the user
enter an Authorization Code.
OFF
ON
OFF
CO Tenancy Group
Only stations in the assigned Tenancy group are
permitted access to the defined CO Line.
eMG80:00-15
eMG800:0-32
UCP:0-100
0
CO/IP Name Display
The IP Phone display can indicate the CO line/IP channel
number or the twelve (12) character name, if assigned
below.
OFF
ON
OFF
CO Name Assign
Each CO Line and IP group can be assigned a twelve
(12)-character name for display purposes.
Max. 12
characters
DISA Account Code
With DISA Account Code “ON”, users are required to
enter a DISA Authorization code. Codes are entered in
‘Authorization Code Table section’.
OFF
ON
ON
DISA CO Access
When enabled, DISA users may access the VoIP facilities
of the system.
OFF
ON
OFF
Wait If VSF Busy
When a DID/DISA call assigned to receive a VSF
announcement arrives and all channels are busy, the call
may wait with Ring back until a channel is available (ON)
or route to the DID/DISA Destination -PGM 167-.
OFF
ON
ON
SMS Outgoing Each CO line can be assigned to support PSTN SMS.
Disable
Enable
Disable
SMS Received Station
When a PSTN SMS is received, the system delivers the
message to the assigned station.
Station ….
Reject Anonymous
Incoming Call
When REJECT ANONYMOUS is enabled, incoming calls
without Caller ID are rejected.
OFF
ON
OFF
Prefix Table ID
When the Prefix Dialing Table (PGM 206) feature is used,
this Prefix Table ID is employed. If this value is set to 0,
the Prefix Table feature is disabled.
0 – 6.
0 means disable
0
LDT Table Index
When LCR is configured, this LDT Table index is
referenced for outgoing calls on this CO/IP Line.
0-10(eMG80),
0-32(eMG800)
0-32(UCP)
1
LDT Zone Number
If the LDT Zone Number of a LDT table (LCR LDT(221))
is equal to this value, the LDT table is available to this CO
Line.
1-100 1
ENBLOCK Sending
This entry determines if the system sends dialed digits to
the ISDN line as they are received (OFF), or collects all
digits and forwards them in a block. (ON).
OFF
ON
ON