iPECS UCP - Page 333

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
318
Table 4.4.4.1-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
DID preserve Name
For DID lines, the CLI is normally displayed only during
ringing. If enabled here, the CLI will be displayed for the
entire call duration.
OFF
ON
OFF
Burst Tone to Caller
When DID Call Wait is assigned for the station, the
system can send audible off-hook signals as a short burst
of tone for DID calls from this CO/IP Line.
OFF
ON
OFF
Collect Call Blocking
This parameter defines the type of Collect Call Blocking
supported for E1 CO lines with R2 signaling. (Intended for
Brazil only)
Disable/
Double Answer/
Double Answer
w/Indication
Disable
Collect Call Answer
Timer
These parameters determine treatment of an incoming
call when Collect Call Blocking Double Answer is
assigned. In this case, the system answers the call and
maintains the connection for the Call Answer time then,
the system will disconnect for the Call Idle time before
finally reconnecting the call.
1-250 (100ms) 10
Collect Call Idle Timer 1-250 (100ms) 20
Gain table index
One of three Gain tables can be configured for TDM
connections.
1-3 1
Tone table index
One of the five Tone table can be configured for use with
the CO/IP Line.
1-5 1
Digit conversion table
index
One of the Digit Conversion Tables can be configured for
use for this CO/IP Line.
eMG80:1-15
eMG800:1-32
UCP:1-32
1
Prepaid Call
The Pre-paid Call feature must be enabled for use by a
station. User can set the budget for the station call charge
in advance.
OFF
ON
OFF
Prepaid Money (0-
999999)
&
Used Prepaid Money
An amount can be associated with the station as
prepayment for outgoing calls. The assigned “Pre-paid
Money” is reduced by the calculated call cost (Call
Metering or cost/minute). This parameter displays the
remaining funds for outgoing calls. Prepaid Money is
often used in small hospitality businesses.
The “Used Pre-paid Money” displays the money that has
been used.
0-999999
0-999999
0
Automatic call
recording destination
When desired, the IP CR server can be used to record
calls on the CO/IP Line. This value defines the Station
Group of the IP CR server. The IP CR Agent object, see
PGM 237, must be assigned as CO Line for proper
operation.
ICLID Usage
An incoming call can be routed to the destination based
on Calling Name.
Disable - ICLID feature is disabled
CLI - ICLID feature is operated with CLI
Name, CLI - ICLID feature is operated with Name and CLI
Disable/
CLI/
Name, CLI
CLI
PBX Code Insertion for
Emergency call
System can insert PBX code automatically if pre-
configured when a user make an emergency call.
Disable,
PBX code1~4
Disable
Timer Attributes
CO CUT OFF TIMER When the Station is assigned Call Time restriction is 00-99 0