iPECS UCP - 5.11 Group Listening

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
346
Table 4.4.5.1-1 SYSTEM ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
New 5 Wake Up
Usage
With the “New Wake-Up” option, the user can assign
five alarm notification times, otherwise only one
Wake-Up time can be set.
OFF
ON
OFF
Easy 5 Wake Up
Usage
If this value is set to ON, and New 5 Wake Up Usage
is also set to ON, each station user can enter his/her
wake up time without entering wake up type and wake
up index.
OFF
ON
OFF
Station VM Feature
Usage
If this option is set to ON, Station VM feature (PGM
127) can be used.
Enhanced features of the VSF/UVM can be disabled.
Features controlled by this setting include as below:
- Company Directory
- Remote Announcement Recording
- Administrator Mailbox
- Distribution List
- Mark a Message as Private, Urgent, or
Delivery Confirmation
- Record Greeting through CCR
- Voice Mail Class of Service
OFF
ON
ON
End code(#) usage in
System Auth Code
If this option is set to ON, End code (#) must be
entered when system Auth code is entered.
OFF
ON
OFF
Remote VM Access
If this value is OFF, the user cannot access to VSF
mailbox via DID, DISA CO call and so on (i.e. through
CO line channel).
OFF
ON
ON
Transfer Tone Usage
If this value is ON, Warning tone is served to the
[transfer to] station. This is only applied to screened
transfer case.
OFF
ON
OFF
CID Password Usage
If this value is ON, a user must enter the CID
password to modify an admin value about CID setting.
OFF
ON
OFF
LCR Dial Tone Detect
If this value is set to ON, the system first checks dial
tone in case on analog CO Lines then LCR dialing is
completed. If no dial tone is detected, the call is
rerouted to Alternate DMT Index.
If LCR type is set to M13, LCR dial tone detect option
is not applied.
OFF
ON
OFF
ICM call log
If this value is set to ON, the system provides an ICM
Call log for iPECS IP and LDP Phones.
OFF
ON
OFF
Mobile Phone
Presence Service port
This is for an interface between eMG and external
server that sends http/xml data. Currently the first
usage of this port is ‘mobile phone presence’ service.
If set to a valid port the presence service will be
implemented and the system will await messages for
presence from the external server.
00001~65535 00000
Mobile Phone
Presence State Sync
When the system receives presence information for a
mobile extension from external server, the system
synchronizes the station’s call state with this presence
information. A busy presence will set the station to
busy.
OFF/
DSS LED only/
Station Status
Station Status