iPECS UCP - Page 392

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
377
Table 4.4.5.17-1 SMDR ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Long Distance Call
Digit Counter
Dialed numbers, which exceed the assigned LD digit count are
considered long distance calls for SMDR and COS purposes.
07-15 07
Print Incoming Call
The system can output records for Incoming calls as well as
outgoing calls. If enabled, incoming as well as outgoing calls
are recorded.
OFF
ON
OFF
Print Lost Call
When incoming call records are enabled, the system can also
provide records for unanswered incoming (abandoned) calls.
OFF
ON
ON
Records In Detail
The system can output detailed call records (ON) or summary
call information (total number of calls, cost and cost for each
station).
OFF
ON
ON
Hidden Dialed Digit
For security purposes, digits dialed for an outgoing call can be
hidden and replaced with “*”. This field defines the number of
digits to hide. The Dialed Digit Hide Option below defines
whether leading or trailing digits are hidden The station must
be assigned for SMDR Hidden digits in ‘Common Attributes
section’.
0~9 0
Dialed Digit Hide
Option
When “HIDDEN DIALED DIGIT” is enabled, above, this field
determines if leading or trailing digits are hidden.
Right/
Left
Right
SMDR Currency Unit
The unit of currency used for call cost can be identified with 3-
characters for easy reference.
Max. 3
characters
SMDR Cost Per
Metering Pulse
When call metering is provided by the PSTN, the cost per
metering pulse can be assigned.
6-digits 000000
SMDR Decimal
Location
This value determines the position of the decimal in the Cost
per Pulse entry above, starting from the right most digits.
0~5 0
Start Timer
To allow for call set-up times through the PSTN, a “Valid call
timer” can be set.
000~250
(msec)
0
Long Distance Code
For SMDR and COS purposes, five (5) Long Distance codes
of up to two (2) digits each can be assigned. If dialed as the
1st digits, the call is considered an LD call.
5 two digit LD
codes, use * as
wild card(any
digit)
SMDR CLI or Ring
Service I
For incoming calls, the system will send the defined data item
for “Field I”. The data item may be CLI, CPN or Ring Service
Time. Note the User dialed number is always provided for an
outgoing call.
RING/
CLI/
CPN
RING
SMDR Ring/CLI/CPN
Service II
For incoming calls, the system will send the defined data item
for “Field II”. The data item may be CLI, CPN or Ring Service
Time.
RING/
CLI/
CPN
CPN
Print MSN
For an ISDN call involving an MSN number, the MSN number
Information can be included in the SMDR Record.
OFF
ON
OFF
Print Serial No
Each SMDR Record can include a record number starting at 1
and incrementing until the records are deleted. The record
number will reset to 1 when SMDR capacity is reached or
SMDR Mail Auto Delete Set is enabled under System
Attributes.
OFF
ON
OFF
SMDR Interface
Service
When enabled, the system stores SMDR data to send to
applications including NMS (Network Management System)
upon request.
OFF
CO CALL,
CO & ICM
CALL
OFF