iPECS UCP - Page 425

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
410
Table 4.4.6.3-1 TERMINAL & CIRCULAR GROUP ATTRIBUTES
ATTRIBUTE − DESCRIPTION RANGE DEFAULT
VSF Announce 2 Timer
After the 1st announcement, the 2nd ANNC TMR is
activated. At expiration, if the call remains queued to the
group, the call is sent to the assigned 2nd VSF
announcement.
000~999
(seconds)
000
VSF Announce 1
Location
The Station Group can be assigned an announcement,
which is played if the call remains queued beyond the
VSF Announce 1 Timer duration. The announcement
location is the VSF Announcement number. An entry of
00 indicates no announcement.
00~200 00: none
VSF Announce 1 Auto
Drop
If this attribute is selected, the call will drop after the 1st
VSF announcement.
Check box
VSF Announce 2
Location
The Station Group can be assigned a 2nd
announcement, which is played if the call remains
queued beyond the VSF Announce 2 Timer duration.
The announcement location is the VSF Announcement
number. An entry of 00 indicates no announcement.
00~200 00: none
VSF Announce 2 Auto
Drop
If this attribute is selected, the call will drop after the 2nd
VSF announcement.
Check box
VSF Announce 2
Repeat Timer
The 2nd announcement can be repeated to callers that
remain in queue at intervals of the Announcement 2
Repeat Timer. Note VSF Announce 2 Repeat below
must be “ON”.
000~999
(seconds)
000
VSF Announce 2
Repeat
After the 2nd announcement, if the call remains queued
to the group, the 2nd VSF announcement can be
repeated at the Announce 2 Repeat Timer interval,
defined above.
OFF
ON
OFF
Overflow Destination
A call to the group will continue to route through the
group until answered or all group members have been
tried. The call will remain at the last station or route to the
assigned overflow destination. If VSF Announcement is
selected, Auto Drop can be checked.
STA/NET or
Station Group/
VSF
Announcement/
Auto Drop/
System SPD
Overflow Timer
A call to the group will remain at the last station in the
group or can be sent to the assigned Overflow
Destination after expiration of the Overflow Timer.
000~600
(seconds)
180
Wrap-Up Timer
After terminating a group call, a Group member will be
maintained in a busy state for the duration of the Wrap-
Up timer.
000~999
(seconds)
002
No Answer Timer
Calls to a station in the group are directed to the station,
if unavailable or unanswered in the No Answer Timer,
the call can be routed based on the assigned hunt
process.
00~99
(seconds)
15
Pilot Station Group
A circular/terminal Station group can be set so that only
calls to the pilot number (station group number) will hunt.
OFF
ON
ON
REPT No Member
If a call is received and no members are on-duty, an ICM
call will return re-order tone, while a CO/IP call will be
routed to the overflow destination.
OFF
ON
OFF
Music Source
A Music source can be assigned so that calls to the
group will receive audio from the assigned source in
Ring back tone/
Internal Music/
Internal Music