iPECS UCP - Page 487

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
472
Table 4.4.8.8-1 SIP PHONE PROVISIONING
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Attributes (PGM 210) apply.
Signaling Port
When SIP phone transports the message to the system, this
port number is employed for messages from the SIP phone.
Port (1-65535) 5060
Preferred Voice CODEC Priority
1
st
priority ~ 4
th
priority
When the system negotiates with the SIP phone, the Codec
priority specified is employed. If only the 1st. priority Codec is
defined, only that Codec is available from the phone.
If the Codec is not supported by the remote party, the call will
fail.
G.711-u
G.711-a
G.723.1
G-729
G.722
None
NTP Setting (Need for TLS)
NTP Server
Address
The IP8800 series phones employ NTP to determine the time of
day. The NTP server id must be configured for the phone.
Max. 32
Characters
NTP Interval
The phone periodically checks the NTP server to determine the
proper time of day.
0-120
(Hours)
1
NTP Time Zone
The phone must be configured with the local Time Zone for
proper operation and time display.
GMT
DST Usage The phone must be configured to support Daylight Saving Time.
ON
OFF
OFF
DSP Setting
Speaker Volume
The default volume level of SIP phone speaker can be set
through the Config file.
1-11,
1-7 (IP8850)
6
Handset Volume
The default volume level of SIP phone handset can be set
through the Config file.
1-11,
1-7 (IP8850)
6
Headset Volume
The default volume level of SIP phone headset can be set
through the Config file.
1-11,
1-7 (IP8850)
6
MAX Handset
Volume
The default maximum volume level of SIP phone handset can
be set through the Config file.
1-11
11
Digit Map
Dial Tone Digit
A digit string can be defined in the Config file so that the SIP
phone will provide a “Second Dial Tone” to the user.
Max. 256
Digits
Inter Digit Timer Inter digit timer between Dial digit in SIP Phone.
01-20
(Sec.)
3
Pause Timer Dial Pause timer in SIP Phone.
01-20
(Sec.)
3
Digit Map Send setup to system numbering plan. Max. 1000
Emergency Code
The Emergency dial code for the SIP phone can be set through
the Config file.
Max. 1000
System Setting
Feature Sync.
With Do Not Disturb and Call Forward feature synchronization
ON, when SIP Phone changes the DND or Call Forward state,
the system is informed of the change in status.
ON
OFF
ON
Auto Idle Timer
Phone goes to idle after this timer when the phone receives
disconnect message or signal from system.
00-99
(Sec.)
5
Check Domain
The IP8800 SIP Phones can be configured to verify the domain
in SIP messages match the registered proxy server.
OFF
ON
ON
Telnet Usage The IP8800 series phones can support Tenet access to the CLI. Enable Disable