iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
34
Table 3.3.2.5-4 FLEXIBLE NUMBERING PLAN PART D (PGM 109)
BTN DISPLAY FEATURE DEFAULT
17
ALL GR AGENT ON/OFF DUT
ENTER NEW #:58*
Code to change the state of the Agent
ON/Off duty in all hunt groups.
58*
18
SLT ACNR CODE
ENTER NEW #:58#
In SLT, user can ACNR feature by using
this numbering plan.
58#
19
ACD SUPERVISOR RING MODE
ENTER NEW #:570
Code to check and change ACD group
Ring mode by ACD group supervisor.
570
20
COMPANY DIRECTORY NAME
ENTER NEW #:563
Code to check and change recording
station subscribe name of Company
Directory feature. (USA Only)
563
21
ISDN SUPP HOLD
ENTER NEW #:57*
ISDN Supplementary Service for HOLD. 57*
22
ISDN SUPP CONF
ENTER NEW #:57#
ISND Supplementary Service for
Conference (Not supported).
57#
23
FORCED SEIZE BUSY STN/CO
ENTER NEW #:56*
Busy Station / CO can be connected with
entering this Code.
56*
24
ADDED FLEX NUMBER PLAN
PRESS FLEX KEY (1-5)
24-1
OVERRIDE DND/CFW
ENTER NEW #:56#
[56#] + Station number, then the station’s
DND or CFW setting will be overridden.
56#
24-2
CANCEL CALL BACK
ENTER NEW #:….
It is used to cancel call back.
24-3
XFER TO VSF ANNC NO
ENTER NEW #:55*
When a station is talking over a CO line
User, [Transfer] + [55*] + Valid system
announcement (01-70), then Outside
user can hear system announcement,
and system starts DISA service.
55*
24-4
CCR
ENTER NEW #:#2
It is used in digit conversion. #2
24-5
UCS SYS CONF GRP JOIN
ENTER NEW #:5*0
It is used to join UCS conference group
by entering the code.
5*0
To Next Page
Loading...
