iPECS UCP - 2.15 Call Forward

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
48
Table 3.3.3.3-1 STATION ISDN ATTRIBUTES (PGM 114)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
5
100-110 COLR SERVICE
(1:ON/0:OFF ) : OFF
COLR (Connected Line Id Restriction),
an ISDN service, removes connected
party Id sent from the PSTN to the calling
party with a RESTRICT instruction in the
CONNECT message.
If enabled here, the system will send the
restrict instruction to the PSTN when the
station answers an ISDN call.
0: OFF
1: ON
OFF
6
100-110 STN CLI 1
100
When not restricted (button 4 & 5 above)
and entry 00 of the CLIP/CLOP Table is
selected in PGM 143-button 1& 2, this
entry is added to the number sent in the
ISDN call SETUP or CONNECT
message in place of the station number.
12 digits Station
number
7
100-110 3.1 kHz AUDIO
(1:ON/0:OFF ) : OFF
When an analog device (SLT or FAX)
uses an ISDN Line in the system, the
Information Element of the ISDN SETUP
message must indicate it only has 3.1
KHz audio capabilities. If a SLT or analog
FAX will be allowed access to the ISDN
Lines, this parameter must be “ON”.
0: OFF
1: ON
OFF
8
100-110 CLI NAME DISP
(1:ON/0:OFF ) : OFF
When the CLI data from the PSTN in the
call SETUP message matches a number
in Speed Dial, the system can display the
name associated
with the Speed Dial bin,
if set to ON.
0: OFF
1: ON
OFF
9
100-110 CLI/REDIRECT
(1:RED/0:CLI) : CLI
When an incoming ISDN call is
Redirected by the ISDN, the call SETUP
message will contain an original and
redirected CLI. This selection determines
if the iPECS Phone will display the
original or redirected number.
0: CLI
1: Redirect
CLI
10
100-110 CLI MSG-WAIT
(1:ON/0:OFF ) : OFF
A log of caller identification can be
maintained for the user, permitting the
user to call back the identified party.
System-wide, up to 1000 entries can be
maintained in the log.
0: OFF
1: ON
OFF
11
100-110 EXT OR ATD
(1:ATD/0:EXT ) : EXT
When the system sends a station
number with CLIP or COLP, the number
can be either the Attendant number or
the number of the station.
0: EXT
1: ATD
EXT