iPECS UCP - Page 650

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
635
Table C-3 STATION DATA
BTN SUB-MENU RANGE DEFAULT REMARK
5 CO/IP Line Queuing EN/DIS ENABLE
6 CO PGM EN/DIS DISABLE
7 Ringing Line Preference EN/DIS ENABLE
8 Speed Dial Access EN/DIS ENABLE
9 UCD Group Service 1: ON, 0: OFF OFF
10 Ring Group Service 1: ON, 0: OFF OFF
11 Two Way Record 1: ON, 0: OFF OFF
12 Message Speed Scroll 0-7 3
Scroll speed for Graphic LCD
Key-set
13 Hot Desk Station 1:ON, 0:OFF OFF
14 Prefer CO/CO Group
CO Access Code
Or CO Group
Access Code
..
15 Send SLT CLI 1:ON, 0:OFF ON
Send CLI info to SLT/Soft/Wit
phone.
16 ACD Member Priority 0 ~ 9 0
17 ez Attendant Password 1: ON, 0: OFF OFF
18 Emergency CO
CO Access Code
Or CO Group
Access Code
Any CO
19 Station Account code required 1: ON, 0: OFF OFF
20 Auto Call recording 1: ON, 0: OFF OFF
21 Call Recording Station Station number
22 Voice Mail Back-up 1: ON, 0: OFF OFF
23 VM Back-up Station Station number
24 VM Back-up Prompt 1: ON, 0: OFF OFF
PGM: 113 - Station Attributes III
1 ADMIN EN/DIS ENABLE
2 VSF Access EN/DIS ENABLE
3 Group Listen EN/DIS DISABLE
4 Override Privilege EN/DIS DISABLE
5 SMDR Hidden Dialed Digits EN/DIS DISABLE
6 Voice Over EN/DIS ENABLE
7 Prime Line 1: HOT, 0: WARM WARM
8 Alarm/Door Bell Attribute EN/DIS DISABLE
9 DID Call Wait 1: ON, 0: OFF ON
10 Left Message Executive 1: ON, 0: OFF ON
11 E & MIC Headset 1: ON, 0: OFF OFF For new Soft-Key Key-set
12 En-block Mode 1: ON, 0: OFF OFF For new Soft-Key Key-set
13 VSF Message Retrieve 1: FIFO, 0: LIFO FIFO
14 VMID Number Station number STA # For adjunct Voice Mail-box id
15 Auto ACD DND dial-pad digit 0 0=no reason code
16 Fwd if OOS 1: ON, 0: OFF OFF
17 Backlight 0 ~2 busy 0: Off, 1: busy, 2: always on
18 VSF Mail Server IP address 0.0.0.0
19 VSF Mail Address Web Admin 132 to modify
20 Block Back Call 1: ON, 0: OFF OFF
21 By Pass DTMF 1: ON, 0: OFF OFF
22 Proctor Monitor 1: ON, 0: OFF OFF