iPECS UCP - Page 66

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
51
Table 3.3.3.3-1 STATION ISDN ATTRIBUTES (PGM 114)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
24-12
100-110 E.164 CLI TO
(1:ON/0:OFF ) : OFF
Send CLI with E.164 format if it is ON. 0: OFF
1: ON
OFF
24-13
100-110 FLEX PAGE
(1-3 ) : 3 PAGE
The iPECS LIP-9030 and 9040 have 8
and 12 Flexible buttons, respectively.
Additional Flex buttons are available
using Flex button pages. The phone can
have up to 3 pages each with the 8 or 12
Flex buttons. Thus, an LIP-9030 can
have 24 Flex buttons and the LIP-9040
can have 36 Flex buttons.
The Navigation Up/Down button is used
to scroll through the Flex buttons pages
assigned.
1-3 3 PAGE
24-14
100-110 ALIGN LCD
(0-2) : NOT ALIGN
For the iPECS LIP-9010/20/30/40,
character alignment for messages to the
phone can be right or left aligned by the
system, or alignment controlled by the
phone (“Not Align”).
0: Not align
1: Left
2: Right
Not Align
24-15
100-110 TWOWA REC AN
00
The two way record announcement can
be recorded to play to the station as
Announcement.
0-200 00
24-16
100-110 LDT ZONE
(001-100 ) : 001
If the LDT Zone Number of a LDT table
(LCR LDT(221)) is equal to this value,
the LDT table is available to this CO
Line.
001-100 001
24-17
100-110 ECM FAX(T.38)
(1:ON/0:OFF ) : ON
ECM stands for Error Correction Mode. If
you failed to send something via Faxes,
you can send it again until it is
successful.
0: OFF
1: ON
ON
24-18
100-110 DISP RESTRICT
(1:ON/0:OFF ) : OFF
When {Display Restricted Caller Number}
in CLI Attributes(113) of a station is ON,
Although the caller number is restricted
in ISDN message, the ringing station
displays the caller number.
0: OFF
1: ON
OFF
24-19
100-110 SMALL WIN USE
(1:ON/0:OFF ) : OFF
If this option is set to ON, small popup is
displayed on the LCD of LIP-9030/9040.
If it is set to OFF, top bar is displayed
instead of small popup.
0: OFF
1: ON
OFF
24-20
100-110 LARGE WIN TMR
(0-5) : 0
When Large popup timer is set to any
value from 1 to 5 except 0, the display of
large popup is disappeared after the
timer expired and then the large popup
information is displayed at top bar.
0-5 0
24-21
100-110 MWI LED
(0-4) : ALL MWI
User can program Message wait lamp for
each type, refer to the range.
0: All MWI
1: VM MWI
2: CLI MWI
3: SMS MW
4: ICM MWI
ALL MWI