iPECS UCP - Page 65

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
50
Table 3.3.3.3-1 STATION ISDN ATTRIBUTES (PGM 114)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
22
100-110 P-MSG DND
(1:ON/0:OFF) : OFF
If it is ON, the pre-selected station
doesn’t receive the ring and the caller
hears DND tone.
0: OFF
1: ON
OFF
23
100-110 P-MSG LANG
(1-6):PROMPT1 U.S
Select voice enabled preselected
message for a station playing toward an
incoming CO call
1~6
(1: US
2:KOREA
3:TURKIYE
4:RUSSIA
5:AUTRALIA
6:GERMANY)
1
24
ADDED STATION ATT4
PRESS FLEX KEY (01-23)
24-1
100-110 STN CLI 2
…………....
Station CLI 2 can be programmed. If a
CO line is set to Station CLI 2, then this
CLI is used for outgoing CLI.
16 Chars None
24-2
100-110 STN CLI 3
…………....
Station CLI 3 can be programmed. If a
CO line is set to Station CLI 3, then this
CLI is used for outgoing CLI.
16 Chars None
24-3
100-110 STN CLI 4
…………....
Station CLI 4 can be programmed. If a
CO line is set to Station CLI 4, then this
CLI is used for outgoing CLI.
16 Chars None
24-4
100-110 STN CLI 5
…………....
Station CLI 5 can be programmed. If a
CO line is set to Station CLI 5, then this
CLI is used for outgoing CLI.
16 Chars None
24-5
100-110 SLT CID TYPE
(0:FSK./1:DTMF) : FSK
SLT can send CID by programming
options.
(0:FSK./1:DT
MF)
FSK
24-6
100-110 WAKEUP ANNC
00
Wakeup Announce can be programmed. 0-200 0
24-7
100-110 CAMP ON ENABLE
(1:ON/0:OFF ) : ON
If it is ON (enabled) then this station will
receive camp on. But if it is OFF
(Disabled) then this station will not
receive camp on by other person.
0: OFF
1: ON
ON
24-8
100-110 GAIN TBL
(1-3) : 1
TDM gain table can be programmed. 1-3 1
24-9
100-110 TONE TBL
(1-5) : 1
Tone table can be programmed. 1-5 1
24-10
100-110 DGT CONV TBL
(01-15) : 00
Set the digit conversion table.
eMG80:1-15
eMG800:1-32
0
24-11
100-110 VIDEO ON CALLING
(1:ON/0:OFF ) : OFF
Video show to called party when calling
(ex. IP Video Door Phone)
0: OFF
1: ON
OFF