iPECS UCP - Page 98

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
83
Table 3.3.5.2-3 CO/IP ATTRIBUTES III (PGM 143)
BTN ATTRIBUTE/DISPLAY DESCRIPTION DEFAULT
20
01-02 INC CLI CHOICE
(1:ORI/0:TRANSIT):TRS
Incoming CLI Choice – When ISDN setup
message have two CLI (Transit Point CLI /
Original CLI), by using this option, CLI can be
chosen.
Transit
21
01-02 CALLING NUM PLAN
(0-6):ISDN/TELEPHONY (1)
ISDN Calling Party Numbering Plan can be
programmable.
0: Unknown.
1: ISDN / Telephony.
2: Data / Numbering.
3: Telex.
4: National Standard.
5: Private.
6: Reserved.
ISDN/
Telephony
22
01-02 CALLED NUM PLAN
(0-6) : UNKNOWN (0)
ISDN Called Party Numbering Plan can be
programmable.
0: Unknown.
1: ISDN / Telephony.
2: Data / Numbering.
3: Telex.
4: National Standard.
5: Private.
6: Reserved.
Unknown
23
01-02 SCREENING (0-3)
USER PROVIDED, NO S (0)
ISDN Screening Indicator can be
programmable.
0: User Provided, No Service.
1: User Provided, Pass.
2: User Provided, Fail.
3: Network Provided.
0
24
ADDED CO LINE ATT3
PRESS FLEX KEY (1-6)
24-1
01-02 CLI TYPE (1-5)
STN CLI 1 (1)
Outgoing CLI can be chosen from CLI 1 to
CLI 5. This program is combined with PGM
114 – Station CLI 1 to Station CLI 5.
1 (Station CLI 1)
24-2
01-02 ISDN PLUSE CODE
….
When incoming CLI start with “+” code, this
Plus code can be translated as this program.
-
24-3
01-02 CP/ALERT INBAND
(1:ON/0:OFF):OFF
Send progress indication with in-band
information in call proceeding and alerting
message.
OFF
24-4
01-02 DISCONNECT INBAND
(1:ON/0:OFF):OFF
Send progress indication with in-band
information in disconnect message.
OFF
24-5
01-02 BURSTTN TO CALLER
(1:ON/0:OFF):OFF
Send to burst tone to caller if it’s set ON. OFF