iPECS UCP - Page 97

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
82
Table 3.3.5.2-3 CO/IP ATTRIBUTES III (PGM 143)
BTN ATTRIBUTE/DISPLAY DESCRIPTION DEFAULT
12
01-02 IN PREFIX INS
(1:ON/0:OFF) : OFF
Regional ISDN providers may use the Local
Area Prefix code for special services. In cases
where the code is not provided in the
incoming call SETUP message, the system
can insert the Local Prefix and Area code in
SMDR, LNR, displays, etc.
OFF
13
01-02 OUT PREFIX INS
(1:ON/0:OFF) : ON
Regional ISDN providers may use the Local
Area Prefix code for special services. The
system can insert the Local Prefix in the
outgoing call SETUP message.
ON
14
01-02 INT ACCESS CODE
….
When an incoming call includes the
international Country code in the ISDN call
SETUP message, the Country code will be
included in the station display.
To include the Country code, Incoming Prefix
insertion (button 12 above) and CLI Display
for the station (PGM 114-button 1) must be
On.
15
01-02 AREA CODE
……
Regional ISDN providers may use the Local
Prefix and Area codes for special services.
The system will insert this Local Area Code in
the call SETUP messages defined under
button 13 above.
-
16
01-02 PREFIX CODE
….
Regional ISDN providers may use the Local
Prefix and Area codes for special services.
The system will insert this Local Prefix Code
in the call SETUP messages defined under
button 13 above.
-
17
01-02 CLI TRANSIT
(1:ORI/0:CFW):CFW
When the system must send CLI to the ISDN
for an off-net call, the CLI can be either the
original caller’s CLI or the CLI of the Off-net
forwarding/transferring station.
CFW
18
01-02 PRESERVE NAME
(1:ON/0:OFF) : OFF
For DID lines, the CLI is normally displayed
only during ringing. If enabled here, the CLI
will be displayed for the entire call duration.
OFF
19
01-02 REDIRECT INFO
NO SERVICE (0)
When the system needs to send Redirecting
number to the ISDN for an off-net call, the
Redirecting number can be either the original
caller’s CLI or the CLI of the Off-net
forwarding/transferring station.
If it is no service then system will not send this
information.
If it is OGR CLI (original CLI) then system will
send original CLI that is received from
incoming CO line.
If it is CFW CLI then system will send
redirecting CLI that is CLI for call off-net call
forwarded station.
NO
SERVICE