iPECS UCP - 2.36 Emergency Call Service; 2.36.1 Emergency Call

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
101
Table 3.3.6.1-1 SYSTEM ATTRIBUTES I (PGM 160)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
24-1
SIP STA MODE
(1:PTP/0:RTD): RTD
SIP phones may set-up a point-to-
point RTP connection (PTP) or to
assure a controlled connection,
RTP can be routed via a VoIP
channel (RTD).
0: RTD
1: PTP
ROUTED
24-2
SYS AUTH END CODE(#)
(1:ON/0:OFF) : OFF
If this value is set to ON, the end
dialing digit (#) must be entered
when system Auth code is entered.
0: OFF
1: ON
OFF
24-3
STN VM FEATURE USAGE
(1:ON/0:OFF) : ON
If this value is set to ON, Station VM
feature (PGM 127) can be used.
0: OFF
1: ON
ON
24-4
REMOTE VM ACCESS
(1:ON/0:OFF) : ON
If this value is OFF, the user cannot
access their VSF mailbox via DID,
DISA CO call and so on (i.e.
through CO line channel).
0: OFF
1: ON
ON
24-5
TRANSFER TONE USAGE
(1:ON/0:OFF) : OFF
If this value is ON, Warning tone is
served to the [transfer to] station.
This is only applied to screened
transfer case.
0: OFF
1: ON
OFF
24-6
LCR DIAL TONE DETECT
(1:ON/0:OFF) : OFF
If this value is set to ON, system
first checks if the CO provides dial
tone in case if analog CO is seized
for LCR dialing.
If there’s no dial tone, the call is
rerouted to Alternate DMT Index.
If LCR type is set to M13, LCR dial
tone detect option is not applied.
0: OFF
1: ON
OFF
24-7
ICM CALL LOG
(1:ON/0:OFF) : OFF
If this value is set to ON, system
save and provide ICM call log for IP
and LDP phone.
0: OFF
1: ON
OFF
24-8
ATD PWORD USAGE
(1:ON/0:OFF) : OFF
If this value is set to ON, system
requests password below cases.
When a user enters attendant
program([PGM] + 0) in attendant
keyset,
When a user enters speed program
in attendant keyset,
When a user assigns attendant
program code([PGM] + 0) to flexible
button in attendant keyset,
0: OFF
1: ON
OFF
24-9
PICKUP STA NAME USAGE
(1:ON/0:OFF) : OFF
Name of picked up station is display
when pickup internal call.
0: OFF
1: ON
OFF
24-10
DISPLAY LCR MODE
(1:ON/0:OFF) : ON
Display “LCR MODE” when LCR is
activated.
0: OFF
1: ON
ON