iPECS UCP - Page 118

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
103
Table 3.3.6.1-1 SYSTEM ATTRIBUTES I (PGM 160)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
24-22
DIAL BY SYSNAME LIST
(0:ALL/1:ZONE) : OFF
If this value is set to "Accessible
System Speed Zone Only", the
system speed dial number of
Accessible system speed zone
(System Speed Zone(232)) is
displayed in {Dial by Name}.
All,
Accessible
System
Speed Zone
Only
ALL
24-23
NO CLI CALL LOG
(1:ON/0:OFF) : OFF
Leave system Call log even though
there is no CLI information if it is
ON. Otherwise Call log is not
leaved.
OFF
ON
OFF
Table 3.3.6.1-2 SYSTEM ATTRIBUTES II (PGM 161)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
OFF-HOOK RING TYPE
(1:MUTE/0:BURST) : MUTE
Off-hook ring can be a single tone
burst or muted normal ring.
0:BURST
1:MUTE
MUTE
2
PAGE WARN TONE
(1 : ON/ 0: OFF) : ON
A warning tone can be sent prior to
a page announcement.
0: OFF
1: ON
ON
3
AUTOMATIC PRIVACY
(1 : ON/ 0: OFF) : ON
Automatic Privacy can be disabled,
allowing stations to join an active
CO/IP call. A warning tone can be
provided, see button 4 below.
0: OFF
1: ON
ON
4
PRIVACY WARN TONE
(1 : ON/ 0: OFF) : ON
If desired, warning tone can be
provided when privacy is overridden.
0: OFF
1: ON
ON
5
ACD PRINT ENABLE
(1 : ON/ 0: OFF) : OFF
ACD statistics can be periodically
sent to the assigned serial port. To
provide periodic reports, this entry
must be ON.
0: OFF
1: ON
OFF
6
ACD PRINT TIMER(1sec)
(001 –255) : 001
This entry defines the time, in 10-
second increments, between the
periodic ACD reports.
001~255
(10 sec)
010
7
CLEAR ACD DATABASE
(1 : ON/ 0: OFF) : OFF
When a periodic report is sent, the
ACD database can be cleared
automatically, if “ON”.
0: OFF
1: ON
OFF
8
OVERRIDE 1
ST
CO GRP
(1: ON/0: OFF) : ON
When a user dials ‘9’, the system
can search all CO/IP Groups for the
first available CO/IP line.
0: OFF
1: ON
ON
9
BASE CODEC TYPE
(0-3): G.711(0)
The default codec can be defined as
G.711 or G.723.1 for decreased
bandwidth needs.
The selected codec will be used on
all internal communications as well
as for remote iPECS devices.
0: G.711
1: G.723.1
2:G.729
3:G.722
G.711