iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
42
Table 3.3.3.2-2 STATION ATTRIBUTES II (PGM 112)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
23
100-110 VSF BK STA
……..
UCS Client may monitor voice
messages for another station as a
backup.
UCS Client will include the message
count for the station in the Voice
message count. This field defines the
UCS Client station number that will be
used as the VMIU/VMIB back up.
station
24
100-110 VSF BK PROM
(1:ON/0:OFF) : OFF
Enables UCS Client to backup VSF
Prompts.
0: OFF
1: ON
OFF
Table 3.3.3.2-3 STATION ATTRIBUTES III (PGM 113)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
100-110 ADMIN
(1:EN/0:DIS) : ENABLE
Enables station access to the
System Database.
0: Disable
1: Enable
Enable
2
100-110 VSF ACCESS
(1:EN/0:DIS) : ENABLE
Permits station access to the built-in
AA/VM.
0: Disable
1: Enable
Enable
3
100-110 GROUP LISTEN
(1:EN/0:DIS) : DISABLE
Enables Group Listen feature, audio
is sent to both the handset and
speaker with the handset
microphone active and
speakerphone microphone OFF.
0: Disable
1: Enable
Disable
4
100-110 OVERRIDE
(1:EN/0:DIS) : DISABLE
Enables intrusion to gain access to
an active CO/IP call.
0: Disable
1: Enable
Disable
5
100-110 SMDR HIDE
(1:EN/0:DIS) : DISABLE
Enables hiding dialed digits in
SMDR output.
0: Disable
1: Enable
Disable
6
100-110 VOICE OVER
(1:EN/0:DIS) : ENABLE
Enables use of Voice Over by
station.
0: Disable
1: Enable
Enable
7
100-110 PRIME LINE
(1:HOT/0:WARM) : WARM
Enables Delayed Prime Line (Idle
Line) activation, see PGM 121, Idle
Line Selection and PGM 182-button
0: WARM
1: HOT
WARM
8
100-110 ALARM/DOORBEL
(1:EN/0:DIS) : DISABLE
Assigns station to receive
Alarm/Doorbell signal.
0: Disable
1: Enable
Disable