iPECS UCP - Page 657

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
642
Table C-5 CO LINE DATA
BTN SUB-MENU RANGE DEFAULT REMARK
12 CO Flash Timer 000~300 050 10 msec. Increments
13 Open Loop Detect Timer 00~20 04 100 msec. Increments
14 ICLID Detect Timer 00~20 00 1 sec. Increments
15 SMS OUTGOING
0: Disable
1: Enable
Disable
16 SMS RCV STATION
17 CO Line Dial Tone Source
0: dial tone
1: INT Music,
2: EXT music,
3: VSF MOH,
4~8: SLT MOH1~5,
9~10: VSF
MOH2~3
dial tone
18 CO Line Ring Back Tone Source
0: ring back tone
1: INT Music,
2: EXT music,
3: VSF MOH,
4~8: SLT MOH1~5,
9~10: VSF
MOH2~3
ring back
tone
19 REJECT ANONYMOUS 1: ON / 0:OFF OFF
20 PREFIX TABLE ID 0-6 0
If prefix table ID is set to 0,
then prefix dialing call cannot
be applied.
If prefix table ID is set to (1-6),
then prefix dialing call can be
applied with PREFIX DIALING
TABLE(PGM 206)
21 Cut Off Timer 00-99 00
Co base call cut off timer can
be set at this field.
22 DISA Delay Timer 0-9 0
23 LDT Table Index 1-10 1
24 DISA Answer Timer 0-9 0
PGM: 143 - ISDN Line Attributes
1 COLP Table Index None
2 CLIP Table Index None
3 EN-BLOC Sending 1: ON, 0: OFF ON
4 Type Of Number 0~4 International
0: Unknown
1: International
2: National
3: Unused
4: Subscriber
5 DID Remove digit count 00~99 00
Received digits deleted from
left
6 TEI Type 1: Auto, 0: Fixed Auto
7 ISDN-SS CD/CR 1: ON, 0: OFF Disable
0: Disable, 1: Deflect,
3: Reroute
(Except USA version)
8 ISDN One Digit Remove 1: ON, 0: OFF OFF (For Italy)
9 Advice of Charge Type 0~5 0
0: None
1: Italy/Spain
2: Finland