iPECS UCP - Page 94

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
79
Table 3.3.5.2-2 CO/IP ATTRIBUTES II (PGM 142)
BTN ATTRIBUTE/DISPLAY DESCRIPTION DEFAULT
6
01-02 MOH: (00-10)
MUSIC 1 (01)
A held call can be connected to one (1) of
three (3) possible audio sources while on Hold
as Music-on-Hold (MOH).
00:REFER TO SYS HOLD
01: INT music
02: EXT music
03: VSF MOH
04: SLT MOH1
05: SLT MOH2
06: SLT MOH3
07: SLT MOH4
08: SLT MOH5
09: VSF MOH2
10:VSF MOH3
01
7
01-02 CO DIAL TONE
(1:ON/0:OFF) : ON
ISDN Lines may provide a digital signal rather
than actual tones.
If the ISDN tone is set to “OFF”, iPECS can
provide the tones.
ON
8
01-02 CO RBACK TONE
(1:ON/0:OFF) : OFF
OFF
9
01-02 CO ERROR TONE
(1:ON/0:OFF) : OFF
OFF
10
01-02 CO BUSY TONE
(1:ON/0:OFF) : OFF
OFF
11
01-02 DISA CO ACCESS
(1:ON/0:OFF) : OFF
Permits DISA users access to the VoIP
facilities of the system.
OFF
12
01-02 FLASH TMR
(000-300 10 ms) : 050
This entry sets the duration of a Flash on the
CO Line.
050
500 msec
13
01-02 OPEN LOOP
(00-20 100ms) : 04
This entry sets the duration of open loop that
will be recognized as a “Disconnect Signal”.
04
14
01-02 ICLI DT TMR
(00-20 SEC) : 00
When a call is received, the system may use
the ICLID (Incoming Caller ID) to route the
call. The system will delay routing a call for
this timer while awaiting ICLID. Enter a 00 to
disable ICLID routing.
00
15
01-02 SMS OUTGOING
(1:EN/0:DIS) : DISABLE
Each CO line can be assigned to support
PSTN SMS.
Disable
16
01-02 SMS RCV STATION
STA : ….
When a PSTN SMS is received, the system
delivers the message to the assigned station.
….