iPECS UCP - 2.27 Diagnostics & Maintenance

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
80
Table 3.3.5.2-2 CO/IP ATTRIBUTES II (PGM 142)
BTN ATTRIBUTE/DISPLAY DESCRIPTION DEFAULT
17
01-02 DL TN:(00-10)
DIAL TONE (00)
One of eleven dial tones can be used by the
CO line.
00:DIAL TONE
01:INT MUSIC
02:EXT MUSIC
03:VSF MOH
04:SLT MOH1
05:SLT MOH2
06:SLT MOH3
07:SLT MOH4
08:SLT MOH5
09:VSF MOH2
10:VSF MOH3
dial tone
18
01-02 RB TN: (00-10)
RING BACK TONE (00)
One of eleven ring back tones can be used by
the CO line.
Ring back tone
19
01-02 REJECT ANONYMOUS
(1:ON/0:OFF) : OFF
When REJECT ANONYMOUS “ON”,
incoming call without Caller ID will be
rejected.
OFF
20
01-02 PREFIX TABLE ID
(0-6) : 0
If prefix table ID is set to 0, then prefix dialing
call cannot be applied.
If prefix table ID is set to (1-6), then prefix
dialing call can be applied with PREFIX
DIALING TABLE (PGM 206)
0
21
01-02 CO CUT OFF TMR
(00-99 MIN) : 00
Co base call cut off timer can be set at this
field.
00
22
01-02 DISA DELAY TMR
(0-9 SEC): 0
It is only used for Russia.
System is connected to DISA call
immediately, and DISA announcement is
played after this timer.
0
23
01-02 LDT TBT INDEX
(00-10) : 01
LCR will be operated with LDT table index. 1
24
01-02 DISA ANS TMR
(0-9 SEC) : 0
It is only used for Russia.
When DISA incoming call, System is
connected after DISA Answer Timer.
0
Table 3.3.5.2-3 CO/IP ATTRIBUTES III (PGM 143)
BTN ATTRIBUTE/DISPLAY DESCRIPTION DEFAULT
1
01-02 COLP TABLE IDX
INDEX : NOT ASSIGNED
When an incoming call on an ISDN Line is
answered, the system will send caller id using
the number from the CLIP/COLP Table –PGM
201- entry defined by this parameter.
None