6.4 Transfer Procedure (Using a Communication Cable)
6-15
6
Transfer with V8
6. Select [Serial Port] for [Communication Port].
7. For [Communication Port], select the port used for connecting V-CP on the computer.
(When using the USB-serial converter, select the COM port set for the USB port.)
8. Specify the baud rate for [Baud Rate].
[57600] bps is set as default. [115200] bps can be set depending on the computer.
Check the available rate, and specify its maximum.
9. When settings are completed, click [OK]. The former [Transfer] dialog is displayed again.
10. Click the [PC ←] button. Data transfer is started.
11. During data transfer, the following dialog is displayed.
On MONITOUCH, the screen is changed to the Main Menu screen shown below.
12. When the data transfer is completed, the display indicating that the data transfer is in process
disappears.
Data transfer has been completed.
To Next Page
Loading...