6.6 Transfer Procedure (Using a Modem)
6-55
6
Transfer with V8
5. When the setting is concluded, click [OK]. The [Transfer] dialog is displayed again.
6. Click [PC ->] for [Transfer Method]. Screen data transfer is started.
Transfer Error Messages Displayed on V-SFT
The following error messages are displayed on the editor.
When screen data transfer with a modem is executed while the Main Menu screen is displayed, a
message “Transferring Data” appears at the bottom left of the screen. The message disappears on
completion of transfer.
For about 15 seconds after the message disappears, the switches and the function switches on the
Main Menu screen do not work.
Error Message Symptom and Solution
No response from target. Check the connection with the other end for power-on/-off
or cable disconnection.
Timeout may occur before a response is returned. Extend
the timeout period.
The circuit is cut. The telephone line is disconnected on the other end.
Command error A command that is not applicable to the target modem is
transferred.
The target line is busy. The target line is busy.
The telephone number is not specified. Set the telephone number.
Cannot detect dial tone. The response “NO DIALTONE” is returned.
To Next Page
Loading...