Hakko Electronics V8 series - Transfer Procedure from the Editor to MONITOUCH

6.4 Transfer Procedure (Using a Communication Cable)
6-24
Transfer Procedure from the Editor to MONITOUCH
1. Connect the LAN port of MONITOUCH (or LAN port of CU-03-3) and the computer using a LAN
cable.
Check the setting, such as connecting status or IP address setting, on the Main Menu screen.
2. On the editor, open the screen data to be transferred.
3. Click [Transfer] from the [File] menu or click the [Transfer] icon on the toolbar.
4. The [Transfer] dialog is displayed.
Select [Display] for [Transfer Device], and [Screen Data] for [Transfer Data].
5. Click the [Communication Setting] button.
The [Communication Setting] dialog is displayed.
OR