Hakko Electronics V8 series - Preface

Preface
Congratulations on purchasing the drawing/editing software (V-SFT-5) for the MONITOUCH V8 series.
For a clearer understanding, the MONITOUCH V8 series Reference Manual focuses on the outline of each
function and the way of using the drawing/editing software (V-SFT-5) according to operating procedures.
Notes:
1. The copyright of the software is possessed by Hakko Electronics Co., Ltd.
2. Reproduction of the contents of the software and this manual, in whole or in part, without permission
of Hakko Electronics Co., Ltd. is prohibited.
3. The specifications of the software and the information in this manual are subject to change without
prior notice.
4. If the specifications of the software do not correspond with the contents of this manual, the software
specifications have priority.
5. No liability is assumed by Hakko Electronics Co., Ltd. with respect to the influence brought by the
result of using the software or this manual.
6. You may use this software on a single central processing unit.
About Trademarks
• Windows, Word and Excel are registered trademarks of Microsoft Corporation in the United States
and other countries.
• All other company names or product names are trademarks or registered trademarks of their
respective holders.
• Programmable logic controllers (PLCs) are products of their respective manufacturers.