Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
100 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
no switchport
The interface is configured as a router port.
The command prompt is as follows:
cli(config-if_RPort-Gi$$$)#
Activate the interface again with the
no shutdown command.
You shut down the interface with the shutdown command.
You activate the interface with the
no shutdown command.
You configure the interface as a switch port with the
switchport command.
You can display the status of this function and other information with the
show ip
interface
command.
unicast-block
Description
With this command, you enable the blocking of unknown unicast frames on an interface.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameter assignment:
unicast-block
Unicast frames are blocked.
To Next Page
Loading...
Need help?
General