Siemens SCALANCE XR-500

Network protocols
7.7 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
348 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call the command without parameters:
snmpagent
Result
The SNMP agent function is enabled.
Further notes
You disable the SNMP agent function with theno snmpagent command.
7.7.2.2
no snmpagent
Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmpagent
Result
The SNMP agent function is disabled.
Further notes
You enable the SNMP agent function with the snmpagent command.
7.7.2.3
snmp agent version
Description
With this command, you configure whether all SNMP queries or only SNMPv3 queries are
processed.