Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
483
Syntax
Call up the command with the following parameters:
ip ospf authentication [{message-digest}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
message-digest
Authentication using MD5
-
If you enter the command without parameters, an unencrypted password is used for
authentication.
Result
The type of authentication is specified.
Further notes
You remove the type of authentication with the no ip ospf authentication command.
You create the password for MD5 with the
ip ospf message-digest-key command.
You create the password with the
ip ospf authentication command.
9.2.4.2
no ip ospf authentication
Description
With this command, you reset the type of authentication back to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ip ospf authentication

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English