Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
485
no ip ospf authentication-key
Description
With this command, you delete the password.
d is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no ip ospf authentication-key
The password is deleted.
You configure the password with the ip ospf authentication-key command.
With this command, you specify the costs for the OSPF interface.
ailable only with layer 3.
To Next Page
Loading...
Need help?
General