Siemens SCALANCE XR-500

Network protocols
7.5 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
322 Configuration Manual, 11/2015, C79000-G8976-C252-10
7.5.1.1
show dhcp server
Description
With this command, you display the IP addresses of the DHCP servers to which the device
forwards the frames.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
Configuration mode.
The command prompt is as follows:
cli> or cli# or cli(config)#
Syntax
Call the command without parameters:
show dhcp server
Result
The IP addresses of the DHCP servers are displayed.
Further notes
With the "ip dhcp server" command, you specify the IP addresses.
7.5.1.2
show ip dhcp relay information
Description
This command displays the DHCP relay agent settings for all or for a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global
configuration mode.
The command prompt is as follows:
cli> or cli# or cli(config)#