Security and authentication
11.5 Port Access Control List Locked Ports
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
731
Call up the command with the following parameters:
show lock port [<interface-type><interface-id>]
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select an interface, the configuration of all interfaces is displayed.
The configuration of the interface for the learning of MAC entries is displayed.
Commands in the Global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
clear-all-static-unicast
Description
With this command, you delete all static unicast MAC address entries from the MAC address
table.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General