Siemens SCALANCE XR-500 Configuration Manual

Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
741
Syntax
Call up the command with the following parameters:
no authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefixlength(0-32)>}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip-address
Specifies the network or the IP address
for which the IP manager is authorized
Enter a valid IP address or a
network
subnet-mask
Subnet mask that restricts the authori-
zation
Enter a valid mask
prefixlength
Decimal representation of the mask as
a number of "1" bits
0 ... 32
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
An authorized manager is deleted from the list.
Further notes
You configure the interfaces and protocols via which an authorized manager is allowed to
access the device with the
authorized-manager ip-source command.
You show the information about the configuration of the authorized managers with the
show
authorized-manager
command.
11.7
Port Based Network Access Control
This section describes commands for working with port-based network access control
(PNAC).
11.7.1
The "show" commands
This section describes commands with which you display various settings.
11.7.1.1
show dot1x
Description
This command shows information about port-based network access control (PNAC).

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English