Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
490 Configuration Manual, 11/2015, C79000-G8976-C252-10
no ip ospf hello-interval
Description
With this command, you delete the interval.
d is available only with layer 3.
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
no ip ospf hello-interval
The interval is deleted.
You configure the interval with the ip ospf hello-interval command.
You show the configuration of the OSPF interface with the
show ip ospf interface
command.
ip ospf message-digest-key
Description
With this command, you specify the password and the ID for authentication with MD5.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General