Layer 2 management protocols
8.1 GARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
390 Configuration Manual, 11/2015, C79000-G8976-C252-10
If you want to enable the function for a specific interface on the device, use the gmrp
command.
You can display the status of this function and other information with the
show vlan device
info
command.
With this command, you enable the GVRP function for all or individual interfaces on the
device.
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Call the command without parameters:
gvrp
In the Global configuration mode: The GVRP function is enabled on the device.
In the Interface configuration mode: The GVRP function is enabled for this interface.
If you have enabled the GARP module, you start GVRP explicitly with this command.
If you want to disable the function for a specific interface on the device, use the
no gvrp
command.
You can display the status of this function and other information with the
show vlan device
info
command.
To Next Page
Loading...
Need help?
General