Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
320 Configuration Manual, 11/2015, C79000-G8976-C252-10
ipv6 dhcp client-id type
Description
With this command, you specify what forms the DUID (DHCP Unique Identifier).
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
ipv6 dhcp client-id type {llt | en | ll}
The parameters have the following meaning:
DUID is based on the link local address and a time stamp
DUID is assigned by the vendor (en = enterprise number)
DUID is based on the link local address
The DUID is specified.
You enable DHCPv6 with the ipv6 address dhcp command.
You display the setting with the
show ipv6 dhcp interface command.
ipv6 dhcp client-id interface
Description
With this command, you specify which IP interface uses a DUID of the type llt or ll.
To Next Page
Loading...
Need help?
General