Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
505
show ipv6 ospf redundancy
Description
This command shows OSPFv3 redundancy.
is available only with layer 3.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ipv6 ospf redundancy
The OSPFv3 redundancy is shown.
show ipv6 ospf route
Description
This command shows the routes that were generated with OSPFv3.
Note
This command is available only with layer 3.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General