Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
478 Configuration Manual, 11/2015, C79000-G8976-C252-10
The filtering is disabled.
With this command, you specify the ID of the router.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call up the command with the following parameters:
router-id <router ip address>
The parameter has the following meaning:
IP address Enter the IP address of the router
or a value in the IP address for-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The ID of the router is specified.
You display the router ID and other information with the show ip ospf interface command.
To Next Page
Loading...
Need help?
General