Siemens SCALANCE XR-500 Configuration Manual

Load control
10.2 Static MAC filtering
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
657
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
vlan<vlan-id(1-4094)>
interface([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<1-8>]])
[forbidden-ports([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/ab,0/c, ...>]
[port-channel <1-8>]])
The parameters have the following meaning:
Parameter
Description
Range of values / note
aa:aa:aa:aa:aa:aa
MAC address of the interface
-
vlan
Keyword for a VLAN connection -
vlan-id
Number of the addressed VLAN
1 ... 4094
interface
Keyword for a an interface description -
interface-type
Type of interface
Enter a valid interface.
0/a-b, 0/c,...
Module no. and port no. of the interface
port-channel
Specifies the name of a port channel
1-8
forbidden-ports
Keyword for the interface description of
the blocked ports
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The entry in the forwarding database is generated.
Further notes
With the show mac-address-table static multicast command, you display the list of
configured entries.
With the
no mac-address-table static multicast command, you delete an entry.
10.2.1.3
no mac-address-table static multicast
Description
With this command, you delete a static multicast MAC address entry from the forwarding
database.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English