Siemens SCALANCE XR-500

Security and authentication
11.7 Port Based Network Access Control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
751
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for a port.
11.7.3.9
dot1x mac-auth port reset
Description
With this command, you reset MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x mac-auth port [mac <aa:aa:aa:aa:aa:aa>] reset
The parameters have the following meaning:
Parameter
Description
Range of values / note
mac
Keyword for a MAC address
-
aa:aa:aa:aa:aa:aa
MAC address of the interface
aa:aa:aa:aa:aa:aa
Result
MAC authentication is reset for the port.
11.7.3.10
dot1x mac-auth vlan-assign
Description
With this command you enable the assignment of the VLAN ID for a MAC address by the
RADIUS server.