Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
549
This section describes commands with which you display various settings.
show vrrp interface
Description
This command shows the settings of VRRP for the interface.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show vrrp
[
interface
{
vlan <VlanId(1-4094)>| <interface-type><interface-id>
}
]
[{
brief|detail|statistics
}]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
shows brief information on VRRP
shows detailed information on VRRP.
shows the statistics of the VRRP pro-
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
To Next Page
Loading...
Need help?
General