Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
603
With this command, you configure the delayed forwarding of RIP updates.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Call up the command with the following parameters:
output-delay <milli-seconds(8-50)>
The parameter has the following meaning:
RIP updates are forwarded only after the set delay.
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General