Siemens SCALANCE XR-500

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
642 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
match route-type {local | remote }
The parameters have the following meaning:
Parameter
Description
Range of values / note
local
Directly connected routes (local interfaces)
-
remote
Learnt or statically configured routes -
Result
The filter for the type of the route is created.
Further notes
You delete the filter for the type of the route with the no match route-type command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.16
no match route-type
Description
With this command, you delete the filter for the type of the route.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#