Siemens SCALANCE XR-500 Configuration Manual

Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
699
Result
The access control list of the selected IP interface is displayed.
11.3.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
11.3.2.1
mac access-list extended
Description
With this command, you generate a MAC access control list and change to the MAC ACL
configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac access-list extended<access-list-number(1-128)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
access-list-number
Number of the access control list
1 ... 128
Result
A MAC access control list has been generated.
You are now in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English