Siemens SCALANCE XR-500

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
239
Further notes
You configure the setting with the spanning-tree mst command (properties).
You display these settings and other information with the commands that start with
show
spanning tree ...
.
6.3.5.5
spanning-tree auto-edge
Description
With this command, you enable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is enabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the no spanning-tree
auto-edge
command.
6.3.5.6
no spanning-tree auto-edge
Description
With this command, you disable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#