Siemens SCALANCE XR-500 Configuration Manual

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
198 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
● The interface is enabled.
● You are in the Interface configuration mode of the VLAN interface.
The command prompt is:
cli (config-if-vlan-$$$) #
$$$ stands for the numbering of the interface.
Syntax
Call the command without parameters:
tia-interface
Result
The TIA interface property is enabled exclusively for the specified VLAN. The function was
disabled on the other interfaces.
Further notes
Note that only one VLAN interface can become the TIA interface.
6.1.4
Commands in the VLAN configuration mode
This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the
vlan $$$ command to change to this mode.
When doing this, you need to replace the
$$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can
be found in the relevant sections.
● If you exit the VLAN Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
6.1.4.1
ports
Description
With this command, you generate a list that specifies the behavior of the interfaces and
replaces the existing VLAN configuration.
● Member Port (tagged port)
The interface is added permanently to the list of incoming and outgoing connections.
Tagged and untagged frames are transferred.
● Untagged Port
The interface transfers untagged frames. If the VLAN ID (PVID) is set, incoming untagged

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English