Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
599
RIP is enabled for the specified IP interface.
This command disables the RIP protocol for an IP interface.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Call up the command with the following parameters:
no network <ip-address>
The parameter has the following meaning:
The IP address for which RIP will be
Specify a valid IP address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
RIP is disabled for the specified IP interface.
This command specifies which route information is forwarded by RIP.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
To Next Page
Loading...
Need help?
General