Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
542 Configuration Manual, 11/2015, C79000-G8976-C252-10
The OSPF interface is inactive.
You enable OSPFv3 routing with the ipv6 router ospf command.
You enable the interface with the no ipv6 ospf passive-interface command.
You display the configuration with the
show ipv6 ospf interface command.
no ipv6 ospf passive-interface
Description
With this command, you enable the OSPFv3 interface.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 ospf passive-interface
The OSPFv3 interface "" is enabled.
You enable OSPFv3 routing with the ipv6 router ospf command.
You deactivate the OSPFv3 interface with the
ipv6 ospf passive-interface command.
You display the configuration with the
show ipv6 ospf interface command.
To Next Page
Loading...
Need help?
General