Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
275
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no ip name-server {ipv4 <ucast_addr> | ipv6 <ip6_addr>} [index <id(1-3)>]
The parameters have the following meaning:
IP address of the DNS server Enter a valid IPv4 address.
IPv6 address of the DNS server
Enter a valid IPv6 address.
The required DNS server was deleted.
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you assign an IPv4 address or an IPv4 subnet to the interface.
To Next Page
Loading...
Need help?
General