Configuration
3.5 PoE
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
122 Configuration Manual, 11/2015, C79000-G8976-C252-10
You configure the value for the parameter "Maximum Power" with the poe pse MaximumPower
command.
poe pse usage
Description
With this command, you set a value (as a percentage) for the "Usage Threshold" parameter.
This specifies how many percent of the maximum power the connected devices will use. As
soon as the power being used by the end devices exceeds this percentage, an event is
triggered. An event is also entered in the log. You display the entries of the log with the
command
show logbook. You will find more information on this command in the section
"show logbook (Page 762)".
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
poe pse usage <percent>
The parameters have the following meaning:
Value for "Usage Threshold" as a percentage.
The value for "Usage Threshold" is configured.
no poe pse usage
Description
With this command, you set the "Usage Threshold" parameter to the default value of 80%.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General