Siemens SCALANCE XR-500 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
222 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call the command without parameters:
spanning-tree
Result
The spanning tree function is enabled.
Further notes
As default the function is "enabled".
You disable the spanning tree function with the
no spanning tree command.
You can display the status of this function and other information with the
show spanning tree
detail
command.
You can display information about active ports with the
show spanning tree active
command.
6.3.4.2
no spanning-tree
Description
With this command, you disable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree
Result
The spanning tree function is disabled.
Further notes
You enable the spanning tree function with the spanning-tree command.
You can display the status of this function and other information with the
show spanning-tree
detail
command.
You can display information about active ports with the
show spanning-tree active
command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English